Updating bios from windows

Launch Easy BCD and go to the BCD Deployment page, paying attention to the “MBR Configuration Options” section at the bottom of the screen: delicate process that requires direct access to the hard drive.This feature shouldn’t be used through a virtualization layer or under custom filesystem drivers.With Easy BCD, this feature-set is expanded to include older versions of Windows along with Linux, Mac OS X, BSD and many more.Easy BCD can be used regardless of whether or not the BCD bootloader is installed to the MBR, but in order for any of the settings visible in Easy BCD to take place upon reboot, the MBR must be configured to use the BCD.Its one and only job is to launch the bootsector code written to the active partition of your boot disk, which in turn is responsible for actually searching for and running your bootloader.There are many cases wherein the MBR and sometimes the bootsector are modified against your will, resulting in a system that doesn’t work the way you want it to.Follow the below robust troubleshooting procedure step-by-step and do not skip any steps.Failure to follow this guide when asked by eth OS or gpu Shack staff (as part of RMA procedure) will result in a voided warranty, as described in the gpu Shack Warranty Agreement.

Consider following scenario: You got a new computer system in which the SATA hard disk controller mode in BIOS settings was set to IDE ( or IDE Compatibility or Standard IDE) instead of AHCI (Advanced Host Controller Interface) or RAID for better compatibility. After sometime you realized it and changed the SATA mode from IDE to AHCI or RAID in BIOS and BOOM!!! Windows will no longer start and will show a BSOD (Blue Screen Of Death) containing error code "". Because Windows can't load the new drivers for AHCI or RAID interface.

You’ll need to reinstall their boot-time helpers after configuring Easy BCD.

The new Windows bootmgr/bcd bootloader is installed to your first-boot hard drive’s MBR the first time you install a “BCD OS” – Windows 8, Windows 7, Windows Vista, and Windows Server 2008 – and every time thereafter it is updated or rewritten depending on its status.

This way, all rigs on one network can report to the same panel. You can run The pool-side reported hashrate should be completely ignored.

The pool reports may report a hashrate of "0", or of just a single GPU.

Leave a Reply